SKU: CP0000005623 SKU e prodhuesit: IPM-1SE/V35-AD Kategori: Communication, Service Providers, TDM Access, Circuit Emulation Brand: CTC Union

Cost-effective LAN deployment (PDH and V.35 over ethernet), Transparent transmission of proprietary signaling for PBX features, including call conference, call
forwarding and SS7, integration of TDM, V.35 and Ethernet devices with lower network expense.
Bypass international toll with a pair of IPM-1SE/V35 and guaranteed internet bandwidth, save cost dramatically, ensure the QoS of voice based on interconnections of TDM telecommunications equipment.

KEY FEATURES

Communication/Service Providers/TDM Access and Communication/Service Providers/Circuit Emulation applications.
Structured/unstructured E1 and V.35 data can be mapped/de-mapped into/from Ethernet packets.
An adaptive clock recovery method for Ingress PDH (PSN -> TDM) clock generation is implemented to support E1 (ITU-T G.824) Jitter performance.

Datasheet

Përshkrimi

General:

Supports IEFT RFC4533 Structure-Agnostic TDM over Packet (SAToP), Metro Ethernet Forum MEF8.
One E1 NRZ Serial Interface with LOS/AIS detection.
One V.35 (Nx64K) interface.
Use Raw Encapsulation method for PDH payload over Ethernet packet.
Supports Circuit Emulation Service over Ethernet (CESoE) transport over Ethernet networks.
Comply with IEFT draft standard for CESoPSN and SAToP; Metro Ethernet Forum MEF8 IA.
Supports both Point-to-Point and Point-to-Multipoint operation.
Supports Adaptive Clock recovery block for Ingress PDH (PSN -> TDM) clock generation. Recovered clock jitter is compliant to ITU-T G.824 (E1 Jitter Control).
Configurable jitter buffer depth to compensate up to 40ms of Packet Delay Variation.
Lost packets processing/compensation via PW (Pseudo Wire) control field Sequence Number.
Provides Subscriber side data traffic bandwidth control to guarantee enough TDM payload bandwidth.
PDH LOS detection triggered PW L field or payload AIS generation at Egress direction (TDM -> PSN).
Configurable IEEE 802.3 DA/SA assignment.

Line interface (CPE side):

Port: One E1 (ITU-T G.703) and one V.35.
Interface: RJ-48c (120 Ohm), BNC (75 Ohm) and M/34 female (V.35, DCE). E1 Line Coding: HDB3.

Ethernet interface (CPE/CO side):

Port: two 100 Base-T Ethernet. One is for downlink and the other is for uplink.
Interface: RJ-45.

Dimensions: 44 x 370 x 215 mm (D x W x H).

Power:

AC: 110 ~ 240V @ 47 ~ 65Hz.
DC: -72V ~ -36V.

Më shumë informacion

Relative humidity	5 ~ 95% non condensing
Storage temperature	0degC~ 85degC
Ambient temperature	0degC ~ 50degC (0degC ~ 65degC, optional)
Management	Console port (CLI) or SNMP-based / Web GUI management